Guide And Manual

This appliance has a polarized plug (one blade wider than the other), to reduce the risk of electrical shock; this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify the plug in any way

The computer will automatically adjust the needle upper position when the machine is switch on, and automatically adjust the needle lower position when you start sewing. Please note that it is a normal phenomenon if you hear a sound coming from the machine (machine adjusting sound) and feel that the sewing is being delayed. It’s not dangerous to sew. get manual here

To test the bobbin thread tension, remove the bobbin case and bobbin from the machine and hold the bobbin case suspended by the thread. Shake it once or twice. If the tension is correct, the thread will unwind by about an inch or two. If the tension is too tight, it will not unwind. If the tension is too loose, the thread will unwind for more than two inches.Reserve sewing is used for locking the and of seams and where reinforcement is needed. At the and of seam, press down the reverse sewing lever and touch the foot control lightly.

The maximum zigzag stitch width for zigzag stitching is “5?; however, the width can be reduced on any pattern. The width increases as you move zigzag dial from “0?-”5?. get manual here

To test the bobbin thread tension, remove the bobbin case and bobbin from the machine and hold the bobbin case suspended by the thread. Shake it once or twice. If the suspended by the thread. Shake it once or twice. If the tension is correct, the thread will unwind by about an inch or two. If the tension is too tight, it will not unwind. If the tension is too loose, the thread will unwind for more than two inches.

Reverse sewing is used for locking the end of seams and where reinforcement is needed. At the end of seam, press down the reserve sewing lever and touch the foot control lightly. Sew a few reverse stitches. Release lever and the machine will sew forwards again.Remove the zigzag foot and attach the buttonhole foot. Adjust the stitch length dial between “0.5?-”1?. The density of the stitch depends on thickness of the fabric. get manual here

Make sure that the power switch is in the ‘OFF’ position. Insert the batteries with the polarities in the correct position as indicated on the machine or connect the AC/DC adapter plug into the AC/DC receptacle on the right side of the machine. Connect the foot control into the foot control receptacle.

Raise the needle to its highest position.Hold the needle and loosen the needle clamp screw. Then remove the old needle.Insert the new needle into the clamp with the flat side facing away from you, toward the rear of the machine. The eye of the needle should be facing the front of the machine. Push the needle up into the needle clamp as far as it will go.Tighten the needle clamp screw. get manual here

Very heavy fabric or too many layers of fabric will force the sewing machine to stop. Thread is tangled in the lower bobbin. Stop the machine. Cut the tangled threads to clear it from the machine. Re-thread both the bobbin and the needle.Poor quality stitching: refer to “Adjust Thread Tension”. When new batteries are installed, the sewing machine should work for approximately 2 hours under normal sewing conditions. Remember that heavy fabric requires more power, so it will reduce the running time of the batteries.

Hold the end of the upper thread with the left hand, and turn the hand wheel slowly anti-clockwise until the needle goes down and up again to its highest position. Pull the upper thread slowly and the lower threads to the back and place them together under the presser foot. get manual here