Guide And Manual

INSTALLATION NOTES
1. Unless specified, mount all Sub-Frame components to vehicle before tightening any bolts.
2. Vehicle should be parked on a level surface with the front suspension normally loaded.
MOUNTING INSTRUCTIONS
1. Locate existing slotted holes in vehicle frame rails directly above front axle.
2. Install Mounting Bracket (#3)RH, using three (3) 5/8? x 2? Capscrews (#10) Washers, and Nylock Nuts provided.
3. For W100-W150 Pickup, Trailduster, & Ramcharger. Install Mounting Bracket (#4)LH using three (3) 5/8? x 2? Capscrews (#10) Washers, and Nylock Nuts

The 2010 Dodge Ram 1500 simply called RAM 1500, the 2010 version available with three engines: A 215-horsepower 3.7-liter V6; a 310-horsepower 4.7-liter V8; and a 390-horsepower 5.7-liter V8. The 4.7 V8 is capable of running on E85 ethanol-blended fuel. The 2010 Dodge RAM truck 1500 owner manual book contain these following sections : Introduction, things to know before starting the vehicles, understanding vehicle features: mirror, seats, driver memory, lights, windshield wipers and washers, tilt steering column, heated steering wheel, understanding instrument panel, starting and operating, emergency troubleshooting

1. Unplug all lights and harnesses connected to factory bumper and remove from truck frame.
2. Remove factory tow frame to install new Top Gun rear bumper. In order to remove tow frame, the bed of the truck has to be loosened on lifted 6 inches off the truck frame. Remove 4 bolts towards the rear of the bed, end loosen but do not remove the 2 bolts towards the front of the bed. Lift bed and remove towing frame.

The forward AFC link movement, which allows more fuel at low to medium boost is accomplished by boost pressure acting on a diaphragm in the housing. The AFC housings, and especially those on 215 hp engines, use a very stiff spring that opposes the movement of the AFC link forward. Full link travel in some cases requires 34+ pounds of boost.
You can adjust the pre-load on this spring by removing the steel plug from the top of the cast aluminum AFC housing and turning the “star wheel” as described in the installation instructions for the

This manual is divided into different areas to assist you with your installation and operation of your steering box support system. This product is not a replacement for a new steering box and/or ball joints, but it will aid in reducing the stress placed on the steering box and associated wear. All steering components should be checked and replaced if necessary prior to addition of the steering box support. Installation should occur on a vehicle properly secured to prevent rolling. Application of lubrication at regular chassis lube intervals will promote bearing life.