Tuesday, March 8, 2011
VW Golf/Jetta/new beetle AWE exhaust system tuning
AWE tuning exhaust system for the purchase of the VR6 engine in celebration of 1.8 T or VW Golf/Jetta/new beetle->. All the others in this exhaust system that distinguishes the exquisite build quality with industry leading performance. Our system also includes a muffler of internal parts of a complete stainless steel construction-T304. Jack stand or ramp, you can complete the installation of this exhaust. Never work in Jack support vehicles. If you don't feel comfortable with this system, contact your local expert for the installation.
This exhaust system, the installation is very straight for ward.
1. remove the OEM exhaust systems. This rear axle beam requires OEM system process before bend
2. install the reverse of OEM exhaust removed AWE. Cut off from the factory, which is not installed on the vehicle exhaust tips, please refer to page 2.
3. to ensure that the appropriate accessories, there are a few things fixed points based on AWE exhaust. Also note the factory exhaust hangers to allow additional settings can be adjusted from the bolt hole slotted. AWE exhaust systems in the fixed point is shown in Figure 1 of the arrow.
4. When you install the midpipe all adjustments until it is complete, place the clamp loose find front. Note the clamp installation (in the figure 2 arrow) on the side of the car's passengers longer posts.
5. coordination and clearance checking serrated lock washer on the enclosed installation after the clamp (arrow in Figure 3) from the entrance to the rear muffler hangers of tailpipes. past extension section rubber Using a small hammer to seat at the end of the post completely washing machines. Washer keeps the exhaust centered and prevent it from moving sideways. In Figure 3, you must make the arrow B at clearance. Maximum clearance between the exhaust pipe and axle beam system to adjust. Once the car is lowered to the ground again, move closer to the exhaust pipe axle beam.
