Wednesday, February 1, 2012
1990 SAAB 900 Repair workshop manual
1990 SAAB 900 Repair workshop manual.Fault code on the picture is ”13212”, which is, according the fault list, means that
Throttle position potentiometer signal on full load is too weak.1990 SAAB 900 Repair workshop manual. When the switch is turned ”OFF” the next fault code won´t be active, instead it shows The same code (13231) again. NOTE: You´ll always get ”13231” as a first fault code, ”no rpm signal” Run starter about 5 seconds , if fault code disappears when ignition is turned off, ”rpm signal” is okay. You cannot read fault codes when engine is running. The next fault code To check if there is any other fault codes recorded, do as follows: 1. Set switch ”ON” 2. After short blink, set it ”OFF” The fault number two will be shown just like the first one. The same goes with all the other fault codes recorded. If there will be no any other faults, this will be shown by continuous longer CE light blinks. STARTING ALL AGAIN If you want, for some reason, to check fault codes again, do as follows: 1. Set switch ”ON” 2. After two short blinks, set switch ”OFF”, fault codes will be shown again from the first fault code. EMPTYING the.
Download: 1990 SAAB 900 Repair workshop manual
