Tuesday, October 30, 2012
For Peugeot Disk replacement procedure Rear Brake pad
This document discusses the procedure to replace rear brake pads and discs on Peugeot 406. The instructions are generally applicable to other Peugeot models.
Getting started guide
1. apply the handbrake.
2. place chocks under the wheels and engage first gear.
3. Loosen the rear wheel nuts using a wrench 19 mm wheel with the car on the ground.
4. Jack up the car and support it safely using Jack stands or ramps. Jack-up preference on both sides at the same time, as it becomes easier to balance the action of the hand brake at the end.
5. Remove the road wheel.
Remove the brake caliper
6. the brake caliper must be removed to allow the brake disc be removed. Working under the car Remove the clip securing brake hose in place. This will flush the hose and tubing. Carefully slide the pipe out of the holder.
7. Remove the lower jaw (Socket 16 mm) clamping screw.
8. Remove the plastic cover on the upper PIN.
9. Use a 6 mm Allen wrench to remove the setscrew.
10. the caliper is now loose and can be carefully lifted away from the disc, making sure to route the brake pipe gently to avoid tension. Support for the suspension spring clip using the string or laces.
Download: here
