Guide And Manual

AVANTI WDP69 User Manual

Removal of external and internal packing. Select your instrument on each floor that is sufficiently strong to support a package when it is fully charged. The unit is equipped with four plastic legs, if it does not meet the level of the floor, to adjust the front feet at unit level of the floor. Locate the appliance from direct sunlight and sources of heat (oven, heating, radiators, etc.). Direct sunlight can reflect the acrylic coating and heat sources may increase consumption of electricity. Extreme temperatures of cold environment may also cause the appliance to not run properly. Allow 2 inches of space between the water dispenser and the wall to allow proper air circulation for cooling compressor. plug the appliance into an exclusive ground properly installed firewall network. Do not cut or remove third (ground) prong CD has to offer from the power cord in any circumstances. Questions about power and/or grounding should be directed to certified electrician or authorized products of AVANTI a service center. This water dispenser is not recommended for outdoor use. does not find a package in an area where the temperature can fall below freezing (32 ° F). Keep area around package, free from dust and dirt. Maintain reserve supply of water bottles from excessive heat and light will not turn off water coolerexcept for maintenance

Before you connect the appliance to the power source, let it be placed upright approximately 2 hours. This will reduce the possibility of a failure in the cooling system of treatment during transportYour water dispenser has been cleaned and disinfected before leaving the factory, but in the case of the problem of taste develop, place two tablespoons of Baking soda and add tap water. Fill the tank again and basic operations, previously outlined, with the exception of the inclusion of the switch market hot "off" to avoid the occurrence of residues in the hot water tank. get manual here