Thursday, December 1, 2011
2005-2006 Subaru Part Number: SUB-100-05 Installation Instructions
READ INSTRUCTIONS COMPLETELY BEFORE INSTALLING THIS BRACKETRON PHONE MOUNT. All instructions are written from the drivers seat position looking forward at the vehicle dash. We advise caution whenever your removing or handling plastic parts of a vehicles dash. WARNING: Unnecessary force or pressure can cause pieces to crack or break. Logo and part number will be right side up and readable when installed.
TOOLS NEEDED: Dash Trim Tool, (Part #SIT-104), #2 Phillips screwdriver.
PARTS INCLUDED: One Custom Bezel Mount and instructions.
LOCATION OF MOUNT: To the right of the radio.
Step 1. Begin installation by removing the bezel that surrounds the shifter. Insert the Dash Trim Tool into the corner of the shifter bezel to release 4 clips that secure this bezel. Set this bezel aside in a safe place.
Step 2. Locate and remove two Phillips screws that secure the bottom of the radio/climate control bezel. Set these two screws aside in a safe place. Use the Dash Trim Tool to release four (4) clips that secure this bezel. Remove bezel and set aside in a safe place.
Step 3. Locate and remove one Phillips screw from the middle radio mounting bracket on the right sdie of the radio. Place Custom Bezel Mount over the screw hole and replace factory screw and tighten.
Step 4. Reinstall the dash in reverse order securing all clips and screws. Install any Bracketron phone holder or Amps compatible device to your Bezel Mount. Your installation is complete.
