Thursday, December 1, 2011
Honda/Kia/Hyundai Electronic Cruise Kit Part Number: 250-1859
Pre-Installation Suggestions
1. It is advisable to disconnect the negative battery cable for 3 minutes before beginning installation, to avoid unintended air bag deployment. Note and record any anti-theft radio codes prior to disconnecting.
2. Remove the driver side lower dash and kick panels. Remove the steering wheel shroud.
Install Electronic Module
1. Plug in the Main Wiring Harness, Switch Harness, and Pedal Interface Harness onto mating connectors of the Cruise Control Module.
2. Place the Cruise Control Module in a secure location behind the driver side dash area near the firewall away from moving parts. Secure with supplied wire ties.
3. Route the Pedal Interface Harness through steering column and down to the accelerator.
Install Pedal Interface Harness
1. Use the diagram and chart below to install the pedal interface harness. Disconnect the Pedal Interface Harness at the 2-pin connectors to ease installation of Posi-tap connections. Figure 6. Remove the cap from the Posi-tap connector. Insert each wire in the groove of the connector as shown in Figure 7. Be sure the pin is centered on the wire when pin contacts the wire. Keep the Posi-tap straight to do this. Screw on the cap by hand until the wire is tightly tapped. Cut the accelerator harness between the two Posi-tap connectors of each selected wire location after re-verifying.
2. Check for good Posi-tap connection: Before continuing cruise installation, plug the 2-pin mating connectors in to each other as shown in Figure 7. Reconnect negative side of battery. Start engine and depress accelerator to confirm operation. Turn off engine and disconnect battery.
a. If a DTC code appears, restart Section C and ensure proper wire matching and good Posi-tap connections.
3. Unplug the 2-pin mating connectors from each other (connected together in the last step) and reconnect to the 2-pin mating connectors of Pedal Interface Harness. Use the foam tape supplied in kit to wrap all connections.
